Datasheet

14
Using the Flash Disk
OL-6452-04
Installing a Flash Disk
Step 8 Remove the Flash Disk from the PC Card slot and place it in an antistatic bag.
Step 9 Close the cover and use a 3/16-inch flat-blade screwdriver to tighten the captive screw.
This completes the procedure for installing and removing a Flash Disk in a Cisco 7100 series router.
Proceed to the “Working with a Flash Disk” section on page 16.
Installing and Removing a Flash Disk in All Other Horizontally Oriented Systems
Use the following procedure to install and eject a Flash Disk in all other systems that have horizontally
oriented PC Card slots:
Step 1 Attach an ESD wrist or ankle strap, connecting the equipment end of the strap to an unfinished chassis
surface.
Step 2 Face the front panel of the system processor that has the PC Card slots, as shown in a of Figure 4.