Datasheet

13
Using the Flash Disk
OL-6452-04
Installing a Flash Disk
The Flash Disk is keyed and cannot be seated the wrong way. The ejector button does not pop out if the
Flash Disk is not completely inserted.
Figure 3 Installing and Ejecting a Flash Disk in a Cisco 7100 Series Router
Step 5
Insert the Flash Disk into the PC Card slot until the Flash Disk completely seats in the connector at the
rear of the slot, and the ejector button pops out toward you.
(See b of Figure 3.)
The Flash Disk does not insert all the way inside the PC Card slot; a portion of the Flash Disk remains
outside the slot. Do not attempt to force the Flash Disk past this point.
Step 6 Close the PC Card slot cover and use a 3/16-inch flat-blade screwdriver to tighten the captive screw.
Step 7 To eject a Flash Disk, lift the PC Card slot cover and press the ejector button—located to the left of the
slot. (See c of Figure 3.)
a
22881
b
c
Front label
(faces down)
Back label
(faces up)
Slot 0
Slot 1