Specifications

-42
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-23401-02
Chapter
show controllers ethernet-controller
This is an example of output from the show controllers ethernet-controller phy command for a specific
interface.
Switch# show controllers ethernet-controller gigabitethernet0/1 phy
GigabitEthernet0/1 (port-number: 1)
-----------------------------------------------------------
General SFP Information
-----------------------------------------------
Identifier : 0x03
Connector : 0x00
Transceiver : 0x00 0x00 0x00 0x08 0x00 0x00 0x00 0x00
Encoding : 0x01
BR_Nominal : 0x0D
Vendor Name : CISCO-METHODE
Vendor Part Number : SP7041
Vendor Revision : 0x44 0x20 0x20 0x20
Vendor Serial Number : 00000MTC111701L3
-----------------------------------------------
EEPROM PAGE A0
-----------------------------------------------
000: 03 04 00 00 00 00 08 00 00 00
010: 00 01 0D 00 00 00 00 00 64 00
020: 43 49 53 43 4F 2D 4D 45 54 48
030: 4F 44 45 20 20 20 01 00 00 00
040: 53 50 37 30 34 31 20 20 20 20
Related Commands
System FCS error frames The total number of frames received on an interface that have a valid length (in bytes) but that do
not have the correct FCS values.
RxPortFifoFull drop
frames
The total number of frames received on an interface that are dropped because the ingress queue
is full.
1. FCS = frame check sequence
2. MTU = maximum transmission unit
Table 3-9 Receive Field Descriptions (continued)
Field Description
Command Description
show controllers
cpu-interface
Displays the state of the CPU network ASIC and send and receive statistics
for packets reaching the CPU.