Specifications

C-28
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Appendix C Cisco ME 3400 Ethernet Access Switch Show Platform Commands
show platform policer cpu
This example shows the policers assigned to a ENI when control protocols are enabled on the interface.
A value of 22 indicates that protocol packets are rate-limited for that protocol. When the protocol is not
enabled, the defaults are the same as for a UNI.
Switch# show platform policer cpu interface fastethernet0/23
Policers assigned for CPU protection
===================================================================
Feature Policer Physical Asic
Index Policer Num
===================================================================
Fa0/23
STP 1 26 0
LACP 2 22 0
8021X 3 26 0
RSVD_STP 4 26 0
PVST_PLUS 5 26 0
CDP 6 22 0
LLDP 7 26 0
DTP 8 26 0
UDLD 9 26 0
PAGP 10 26 0
VTP 11 26 0
CISCO_L2 12 22 0
KEEPALIVE 13 22 0
CFM 14 255 0
SWITCH_MAC 15 26 0
SWITCH_ROUTER_MAC 16 26 0
SWITCH_IGMP 17 22 0
SWITCH_L2PT 18 22 0
This example shows the default policers assigned to NNIs. Most protocols have no policers assigned to
NNIs. A value of 255 means that no policer is assigned to the port for the protocol.
Switch #show platform policer cpu interface gigabitethernet 0/1
Policers assigned for CPU protection
===================================================================
Feature Policer Physical Asic
Index Policer Num
===================================================================
Gi0/1
STP 1 255 0
LACP 2 255 0
8021X 3 255 0
RSVD_STP 4 255 0
PVST_PLUS 5 255 0
CDP 6 255 0
LLDP 7 255 0
DTP 8 255 0
UDLD 9 255 0
PAGP 10 255 0
VTP 11 255 0
CISCO_L2 12 255 0
KEEPALIVE 13 255 0
CFM 14 255 0
SWITCH_MAC 15 255 0
SWITCH_ROUTER_MAC 16 255 0
SWITCH_IGMP 17 255 0
SWITCH_L2PT 18 255 0