Specifications

2-545
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
snmp-server enable traps
Command History
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Note Informs are not supported in SNMPv1.
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
Examples This example shows how to send port security traps to the NMS:
Switch(config)# snmp-server enable traps port security
You can verify your setting by entering the show running-config privileged EXEC command.
Related Commands
Release Modification
12.2(25)EX This command was introduced.
12.2(46)SE The dot1x [auth-fail-vlan | guest-vlan | no-auth-fail-vlan | no-guest-vlan ] keywords
were added.
12.2(50)SE The cpu threshold keywords were added.
Command Description
show running-config Displays the operating configuration. For syntax information, use this link to
the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
snmp-server host Specifies the host that receives SNMP traps.