Specifications

2-543
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
snmp-server enable traps
dot1x [auth-fail-vlan |
guest-vlan |
no-auth-fail-vlan |
no-guest-vlan]
(Optional) Enable IEEE 802.1x traps. The keywords have these meanings:
• auth-fail-vlan—(Optional) Generate a trap when the port moves to the
configured restricted VLAN.
• guest-vlan—(Optional) Generate a trap when the port moves to the
configured guest VLAN.
• no-auth-fail-vlan—(Optional) Generate a trap when a port tries to enter
the restricted VLAN, but cannot because the restricted VLAN is not
configured.
• no-guest-vlan—(Optional) Generate a trap when a port tries to enter the
guest VLAN, but cannot because the guest VLAN is not configured.
Note When the snmp-server enable traps dot1x command is entered
(without any other keywords specified), all the IEEE 802.1x traps are
enabled.
entity (Optional) Enable SNMP entity traps.
envmon [fan |
shutdown | status |
supply | temperature]
Optional) Enable SNMP environmental traps. The keywords have these
meanings:
• fan—(Optional) Enable fan traps.
• shutdown—(Optional) Enable environmental monitor shutdown traps.
• status—(Optional) Enable SNMP environmental status-change traps.
• supply—(Optional) Enable environmental monitor power-supply traps.
• temperature—(Optional) Enable environmental monitor temperature
traps.
ethernet (Optional) Enable SNMP Ethernet traps.
flash (Optional) Enable SNMP flash notifications.
hsrp (Optional) Enable Hot Standby Router Protocol (HSRP) traps.
ipmulticast (Optional) Enable IP multicast routing traps.
mac-notification (Optional) Enable MAC address notification traps.
msdp (Optional) Enable Multicast Source Discovery Protocol (MSDP) traps.
ospf [cisco-specific |
errors | lsa | rate-limit |
retransmit |
state-change]
(Optional) Enable Open Shortest Path First (OSPF) traps. The keywords have
these meanings:
• cisco-specific—(Optional) Enable Cisco-specific traps.
• errors—(Optional) Enable error traps.
• lsa—(Optional) Enable link-state advertisement (LSA) traps.
• rate-limit—(Optional) Enable rate-limit traps.
• retransmit—(Optional) Enable packet-retransmit traps.
• state-change—(Optional) Enable state-change traps.
pim
[invalid-pim-message |
neighbor-change |
rp-mapping-change]
(Optional) Enable Protocol-Independent Multicast (PIM) traps. The
keywords have these meanings:
• invalid-pim-message—(Optional) Enable invalid PIM message traps.
• neighbor-change—(Optional) Enable PIM neighbor-change traps.
• rp-mapping-change—(Optional) Enable rendezvous point
(RP)-mapping change traps.