Specifications

2-542
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
snmp-server enable traps
snmp-server enable traps
Use the snmp-server enable traps global configuration command to enable the switch to send Simple
Network Management Protocol (SNMP) notifications for various traps or inform requests to the network
management system (NMS). Use the no form of this command to return to the default setting.
snmp-server enable traps [bgp | bridge [newroot] [topologychange] | config | copy-config | cpu
threshold | {dot1x [auth-fail-vlan | guest-vlan | no-auth-fail-vlan | no-guest-vlan]} | entity
| envmon [fan | shutdown | status | supply | temperature] | ethernet | flash | hsrp | ipmulticast
| mac-notification | msdp | ospf [cisco-specific | errors | lsa | rate-limit | retransmit |
state-change] | pim [invalid-pim-message | neighbor-change | rp-mapping-change] |
port-security [trap-rate value] | rtr | snmp [authentication | coldstart | linkdown | linkup |
warmstart] | storm-control trap-rate value | stpx [inconsistency] [root-inconsistency]
[loop-inconsistency] | syslog |
tty | vlan-membership | vlancreate | vlandelete]
no snmp-server enable traps [bgp | bridge [newroot] [topologychange] | config | copy-config |
cpu threshold | {dot1x [auth-fail-vlan | guest-vlan | no-auth-fail-vlan | no-guest-vlan]} |
entity | envmon [fan | shutdown | status | supply | temperature] | ethernet | flash | hsrp |
ipmulticast | mac-notification | msdp | ospf [cisco-specific | errors | lsa | rate-limit |
retransmit | state-change] | pim [invalid-pim-message | neighbor-change |
rp-mapping-change] | port-security [trap-rate value] | rtr | snmp [authentication | coldstart
| linkdown | linkup | warmstart] | storm-control trap-rate value | stpx [inconsistency]
[root-inconsistency] [loop-inconsistency] | syslog |
tty | vlan-membership | vlancreate |
vlandelete]
Syntax Description bgp (Optional) Enable Border Gateway Protocol (BGP) state-change traps.
Note This keyword is supported only when the metro IP access image is
running on the switch.
bridge [newroot]
[topologychange]
(Optional) Generate Spanning Tree Protocol (STP) bridge MIB traps. The
keywords have these meanings:
• newroot—(Optional) Enable SNMP STP bridge MIB new root traps.
• topologychange—(Optional) Enable SNMP STP bridge MIB topology
change traps.
config (Optional) Enable SNMP configuration traps.
copy-config (Optional) Enable SNMP copy-configuration traps.
cpu threshold (Optional) Allow CPU-related traps.