Specifications

2-541
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
snmp mib rep trap-rate
snmp mib rep trap-rate
Use the snmp mib rep trap-rate global configuration command to configure the sending of Resilient
Ethernet Protocol (REP) SNMP traps when there is a link operational status or port role change. Use the
no version of the command to disable sending of the REP trap.
snmp mib rep trap-rate value
no snmp mib rep trap-rate
Syntax Description
Defaults Sending REP traps is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to enable the switch to send REP specific traps corresponding to link operational
status changes and port role changes.
Examples This example configures the switch to send REP traps at a rate of 10 per second:
Switch(config)# snmp mib rep trap-rate 10
Related Commands
trap-rate value Set the number of REP traps sent per second. The range is from 0 to 1000. The
default is 0 (no limit imposed; a trap is sent at every occurrence).
Release Modification
12.2(40)SE This command was introduced.
Command Description
show running config Verifies that REP traps are configured.