Specifications

2-411
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
show interfaces transceivers
show interfaces transceivers
Use the show interfaces transceivers privileged EXEC command to display the physical properties of
a small form-factor pluggable (SFP) module interface.
show interfaces [interface-id] transceiver [detail | dom-supported-list | module number |
properties | threshold-table] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show interfaces interface-id transceiver properties command:
Switch# show interfaces gigabitethernet0/1 transceiver properties
Name : Gi0/1
Administrative Speed: auto
Operational Speed: auto
Administrative Duplex: auto
Administrative Power Inline: enable
Operational Duplex: auto
Administrative Auto-MDIX: off
Operational Auto-MDIX: off
interface-id (Optional) Display configuration and status for a specified physical
interface.
detail (Optional) Display calibration properties, including high and low numbers
and any alarm information for any Digital Optical Monitoring
(DoM)-capable transceiver if one is installed in the switch.
dom-supported-list (Optional) List all supported DoM transceivers.
module number (Optional) Limit display to interfaces on module on the switch. The range
is
1 to 9. This option is not available if you entered a specific interface ID.
properties (Optional) Display speed, duplex, and inline power settings on an interface.
threshold-table (Optional) Display alarm and warning threshold table
| begin (Optional) Display begins with the line that matches the expression
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)EY This command was introduced.
12.2(44)SE The dom-supported-list and threshold-table keywords were added.