Specifications

2-262
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-07
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
pagp learn-method
Note When the link partner to the Cisco ME switch is a physical learner, we recommend that you configure
the switch as a physical-port learner. Use the pagp learn-method physical-port interface configuration
command, and set the load-distribution method based on the source MAC address by using the
port-channel load-balance src-mac global configuration command. Only use the pagp learn-method
interface configuration command in this situation.
Examples This example shows how to set the learning method to learn the address on the physical port within the
EtherChannel:
Switch(config-if)# pagp learn-method physical-port
This example shows how to set the learning method to learn the address on the port-channel within the
EtherChannel:
Switch(config-if)# pagp learn-method aggregation-port
You can verify your settings by entering the show running-config privileged EXEC command or the
show pagp channel-group-number internal privileged EXEC command.
Related Commands Command Description
pagp port-priority Selects a port over which all traffic through the EtherChannel is sent.
show pagp Displays PAgP channel-group information.
show running-config Displays the operating configuration. For syntax information, use this link to
the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command_
reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.