Installation guide
21
Release Notes for the Cisco ME 3400 Ethernet Access Switch, Cisco IOS Release 12.2(44)SE
OL-14632-01
Documentation Updates
ErrorMessage PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could not
be programmed into TCAM and are being covered by a less specific prefix
Explanation A more specific prefix could not be programmed into Ternary Content Addressable
Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The
output of the show platform ip unicast failed route privileged EXEC command lists the failed
prefixes.
Recommended Action No action is required.
Error Message REP-4-LINKSTATUS: [chars] (segment [dec]) is [chars]
Explanation
The Resilient Ethernet Protocol (REP) link status has changed. The first [chars] is the
interface name that has a link-status change. The [dec] is the REP segment number of the interface.
The second [chars] is the new link status.
Recommended Action No action is required.
Error Message REP-5-PREEMPTIONFAIL: can not perform preemption on segment [dec] due
to [char]
Explanation The Resilient Ethernet Protocol (REP) preempt operation failed. This could be due to
an invalid port ID or a neighbor_offset number specified with the rep block port interface
configuration command. This could also be caused by entering the rep block port preferred
interface configuration command if there is no REP port configured with the preferred keyword.
[dec] is the segment number, and [char] is the reason for the failure.
Recommended Action Correct the configuration, and run REP manual preemption on the primary
edge port by entering the rep preempt segment command.
Changed System Message
This system message has changed (both explanation and action).
Error Message EC-5-CANNOT_BUNDLE1: Port-channel [chars] is down, port [chars] will
remain stand-alone.
Explanation The aggregation port is down. The port remains standalone until the aggregation port is
up. The first [chars] is the EtherChannel. The second [chars] is the port number.
Recommended Action Ensure that the other ports in the bundle have the same configuration.