Installation guide
20
Release Notes for the Cisco ME 3400 Ethernet Access Switch, Cisco IOS Release 12.2(44)SE
OL-14632-01
Documentation Updates
Updates to the System Message Guide
These sections include messages that have been added to or changed in the system message guide.
New System Messages
These new messages have been added to the system message guide:
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars]
Explanation The client MAC address could not be added to the MAC address table because the
hardware memory is full or the address is a secure address on another port. [enet] is the supplicant
MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is
enabled.
Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.
If the client address is on another port, manually remove it from that port.
Error Message SPANTREE-6-PORTADD_ALL_VLANS: [chars] added to all Vlans
Explanation
The interface has been added to all VLANs. [chars] is the added interface.
Recommended Action No action is required.
Error Message SPANTREE-6-PORTDEL_ALL_VLANS: [chars] deleted from all Vlans
Explanation
The interface has been deleted from all VLANs. [chars] is the deleted interface.
Recommended Action No action is required.
Error Message SW_VLAN-6-VTP_DOMAIN_NAME_CHG: VTP domain name changed to [chars].
Explanation
The VLAN Trunking Protocol (VTP) domain name was changed through the
configuration to the name specified in the message. [chars] is the changed domain name.
Recommended Action No action is required.
ErrorMessage PLATFORM_ENV-1-DUAL_PWR: Faulty internal power supply [chars] detected
Explanation
A faulty internal power supply was detected in one of the two power supplies on the
switch. [chars] is the power supply name.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the “Error
Message Tracebacks Reports” section of the system message guide.