Specifications

2-282
Cisco ME 2400 Ethernet Access Switch Command Reference
OL-9643-03
Chapter 2 Cisco ME 2400 Ethernet Access Switch Cisco IOS Commands
show interfaces
Administrative private-vlan trunk Native VLAN tagging: enabled
Administrative private-vlan trunk encapsulation: dot1q
Administrative private-vlan trunk normal VLANs: none
Administrative private-vlan trunk private VLANs: none
Operational private-vlan:
20 (VLAN0020) 25 (VLAN0025)
30 (VLAN0030)
35 (VLAN0035)
<output truncated>
This is an example of output from the show interfaces interface-id trunk command. It displays trunking
information for the port.
Switch# show interfaces gigabitethernet0/1 trunk
Port Mode Encapsulation Status Native vlan
Gi0/1 auto negotiate trunking 1
Port Vlans allowed on trunk
Gi0/1 1-4094
Port Vlans allowed and active in management domain
Gi0/1 1-4
Port Vlans in spanning tree forwarding state and not pruned
Gi0/1 1-4
This is an example of output from the show interfaces transceiver properties command. If you do not
specify an interface, the output of the command shows the status on all switch ports:
Switch# show interfaces transceiver properties
Name : Fa0/1
Administrative Speed: auto
Administrative Duplex: auto
Administrative Auto-MDIX: on
Administrative Power Inline: N/A
Operational Speed: 100
Operational Duplex: full
Operational Auto-MDIX: on
Name : Fa0/2
Administrative Speed: auto
Administrative Duplex: auto
Administrative Auto-MDIX: on
Administrative Power Inline: N/A
Operational Speed: 100
Operational Duplex: full
Operational Auto-MDIX: on
<output truncated>