Datasheet

Configuring Voice Ports
Troubleshooting Analog and Digital Voice Port Configurations
VC-113
Cisco IOS Voice, Video, and Fax Configuration Guide
Tone Injection Tests
To inject a test tone into a voice port, use the following commands in privileged EXEC mode:
Command Purpose
Step 1
Cisco 2600 and 3600 Series Routers Analog Voice Ports
Router# test voice port slot/subunit/port inject-tone
{local | network} {1000hz | 2000hz | 200hz | 3000hz |
300hz | 3200hz | 3400hz | 500hz | quiet}
Cisco 2600 and 3600 Series Routers Digital Voice Ports
Router# test voice port slot/port:ds0-group
inject-tone {local | network}{1000hz | 2000hz | 200hz
| 3000hz | 300hz | 3200hz | 3400hz | 500hz | quiet}
Cisco MC3810 Multiservice Concentrators Analog Voice Ports
Router# test voice port slot/port detector inject-tone
{local | network} {1000hz | 2000hz | 200hz | 3000hz |
300hz | 3200hz | 3400hz | 500hz | quiet}
Cisco MC3810 Multiservice Concentrators Digital Voice Ports
Router# test voice port slot:ds0-group inject-tone
{local | network} {1000hz | 2000hz | 200hz | 3000hz |
300hz | 3200hz | 3400hz | 500hz | quiet}
Identifies the voice port you want to test and enter
keywords for the direction to send the test tone and
for the frequency of the test tone.
Note A call must be established on the voice
port under test.
Step 2
Cisco 2600 and 3600 Series Routers Analog Voice Ports
Router# test voice port slot/subunit/port inject-tone
disable
Cisco 2600 and 3600 Series Routers Digital Voice Ports
Router# test voice port slot/port:ds0-group
inject-tone disable
Cisco MC3810 Multiservice Concentrators Analog Voice Ports
Router# test voice port slot/port detector inject-tone
disable
Cisco MC3810 Multiservice Concentrators Digital Voice Ports
Router# test voice port slot:ds0-group inject-tone
disable
Identifies the voice port on which you want to end
the test and enter the keyword disable to end the
test tone.
Note The disable keyword is available only if a
test condition is already activated.