Specifications

Configuration Views Switch Resource Management Configuration View
Device Management Page 67 Cisco LightStream 1010
Active SVCs
The number of active Switched Virtual Channels
(SVCs) at this interface.
PVPs
The number of Permanent Virtual Paths (PVPs) at
this interface.
PVCs
The number of Permanent Virtual Channels
(PVCs) at this interface.
Configured VPs
The number of configured Virtual Paths at this
interface.
SVC Minimum VCI
The minimum Virtual Channel Identifier (VCI)
number for any SVC connection. The number
smaller than any new VCI will be allocated to any
new PVC. This applies to every Virtual Path
Identifier (VPI) number of the physical interface
and every logical port.
VC Dest Address
The twenty byte ATM address of the destination
ATM interface for soft ATM PVC/PVP.
Switch Resource Management
Configuration View
Access: From the Icon Subviews menu for the Switching
app icon, select Resource Management.
This view contains more detailed network
configuration information for the device.
This view is divided into two tables that provide
the following information.
Default QOS Objective
This table contains resource management
configuration information for default Quality of
Service (QoS) objective values used when a
signalling request is received on a UNI interface.
The following fields are cross-referenced by the
QoS categories CBR, VBR RT, and VBR NRT.
QOS Max
The default maximum Cell Transfer Delay (CTD)
for the service category. It applies only to
Constant Bit Rate (CBR) and Variable Bit Rate-
Real Time (VBR-RT) service categories. Specifying
a value of 16777215 signifies that this parameter
should not be checked during connection setup.
The units are measured in microseconds.