Specifications

Application Views Switching Application (LS_Switch_App)
Device Management Page 42 Cisco LightStream 1010
Route Optimization
Enables or disables the route optimization feature
on an ATM interface. Table 11 describes Route
Optimization values.
The remaining fields within this table will only be
active if Route Optimization is not set to
‘disable’.
Interval
Specifies how often route optimization takes place
on the interface.
Start Hour
Specifies the starting hour when route
optimization will begin on an ATM interface.
Start Minute
Specifies the starting minute when route
optimization will begin on an ATM interface.
End Hour
Specifies the ending hour when route
optimization will stop on an ATM interface.
End Minute
Specifies the ending minute when route
optimization will stop on an ATM interface.
Double-clicking any entry in this table will open
the Switch Application PNNI Interface View, which
contains the same information as the table view
except it pertains only to the selected entry.
Table 11: Optimization Values
Value Description
disable disables route optimization on the
interface
soft enables route optimization only for
any ATM soft Permanent Virtual
Circuits (PVCs) on the interface
switched enables route optimization only for
any ATM switched PVCs on the
interface
switchedAndSoft enables route optimization for both
ATM soft and switched PVCs