Specifications

Application Views Switching Application (LS_Switch_App)
Device Management Page 32 Cisco LightStream 1010
Span Type
The VCL span type; either a transit one or a
terminating one.
Config Type
The configuration type of the VCL. Possible values
are permanent, switch, soft, or other.
Remote Addr
Soft PVC target address if this is the calling side
of the connection else Soft PVC source address if
this is the called side.
Remote VPI
Soft PVC target VPI in the calling side of the
connection. This value is zero if this is the called
side.
Remote VCI
Soft PVC target VCI in the calling side of the
connection. This value is zero if this is the called
side.
Rx UPC Mode
This value represents the Usage Parameter
Control (UPC) object. Possible values are:
passing, tagging, dropping, or local shaping.
EPD Enable
This value represents the Early Packet Discard
(EPD) operation and is either enabled or disabled.
Conn State
The Connection State of this VCL, possible values
are setup, release, not installed, down, and
up.
Switch Application VPL Table View
This view contains the following virtual path link
information:
IF
The interface value associated with this entry.
Admin Status
The value of this object identifies the desired
administrative status of the VPL. Possible states
are up or down indicating that the traffic flow is
enabled or disabled respectively
Oper Status
This value indicates the current status of the VPL.
Possible values are up, down, and unknown.
Rcv Index
The value of this object identifies the row in the
Traffic Description Parameter Table which applies
to the receive direction on the VPL.
Xmit Index
The value of this object identifies the row in the
Traffic Description Parameter Table which applies
to the transmit direction on the VPL.