Specifications

Channelized and Electrical Interface Line Card Installation and Configuration

78-16417-02

Line Card Cable-Management Bracket

Note It is not necessary to remove the interface cables from the line card cable-management bracket. The

bracket (with attached cables) can be hooked to the cable-management tray or a bracket on the chassis

until a new line card is installed.

Step 4 For multiport line card cable-management brackets, proceed upward and remove the interface from the

Velcro strap on the end of the cable standoff. (See Figure 14.)

For single-port line card cable-management brackets, carefully remove the interface cable from the cable

clip. (See Figure 15.) Avoid any kinks or sharp bends in the cable.

Step 5 Repeat Step 3 and Step 4 for all remaining interface cables, then proceed to Step 6.

Step 6 For multiport line card cable-management brackets, loosen the captive installation screw at each end of

the cable-management bracket and remove the bracket from the line card.

For single-port line card cable-management brackets, loosen the captive installation screw on the

cable-management bracket and remove the bracket from the line card.