User guide

ManualsBrandsCisco ManualsComputer equipmentISDN GW 3241

Domain name (DNS

suffix)

Specifies an optional suffix to add when

performing DNS lookups.

This can allow you to use non-fully qualified

host names when referring to a device by

host name instead of IP address.

For example, if the domain name is set to

codian.com, then a request to the name

server to look up the IP address of host

endpoint will actually lookup endpoint.codian.

com.

IP Status

Use the IP Status fields to quickly verify the current IP settings for the appropriate Ethernet port of the ISDN gateway,

which were obtained using DHCP or configured manually (see

IP Configuration Settings) including:

● Host name

● DHCP

● IP address

● Subnet mask

● Default gateway

● Name server (DNS)

● Secondary name server (DNS)

● Domain name (DNS suffix)

Ethernet Configuration

These settings determine the Ethernet settings for the appropriate port of the ISDN gateway. Refer to the table for

assistance with these settings. When you have finished, you must press Update Ethernet configuration to make the

changes take effect.

Field Field Description Usage Tips

Ethernet settings

Specify whether you want this Ethernet port

to automatically negotiate its Ethernet

settings with the device it is connected to, or

if it should obtain its configuration manually

using fixed values that you must specify.

It is important that your Ethernet settings

match those of the device to which this port

is connected. For example, both devices

must be configured to use automatic

negotiation, or both configured with fixed

and matching speed and duplex settings (see

below).

Manual Configuration

Speed

Identifies the connection speed: 10 Mbit/s,

100 Mbit/s and 1000 Mbit/s.

The connection speed must match that of

the device to which this port is connected.

You only need to select this option if you

have chosen manual Ethernet settings, as

described above.

Duplex

Identifies the connection duplex mode:

● Full duplex

Both devices can send data to each

other at the same time

● Half duplex

Only one device can send to the

other at a time

The duplex setting must match that of the

device to which this port is connected.

You only need to select this option if you

have chosen manual Ethernet settings, as

described above.

Ethernet Status

Field Field Description Usage Tips

Link status

Indicates whether this Ethernet port is

connected to or disconnected from the

network.

Codian ISDN GW 3200 Series User Guide Version 1.0(1.18)