Operation Manual

Installing the 7914 Expansion Module

Note To ensure a successful installation of the

7914

Expansion Module, make sure you have read the

entire “Before You Begin” section on page 3.

To install the 7914 Expansion Module, you need to perform the

following steps.

1. Remove the Footstand from the Cisco IP Phone 7960

2. Connect the Support Bar to the Cisco IP Phone 7960

3. Connect the 7914 Expansion Module to the Support Bar

4. Connect the RS 232 Cable

5. Connect the Power Supply

6. Connect the Footstand

Refer to the detailed instructions and corresponding

illustrations that follow for each of these high-level steps.

Caution To ensure a successful installation, verify with your

system administrator that your phone is ready for

the 7914

Expansion Module and that Cisco

CallManager is installed and configured for the

7914

Expansion Module. See the Cisco IP Phone

Administration Guide for Cisco

CallManager for

more information. Make sure that you have all of

the parts that you need (see the

“Before You Begin”

section on page 3).

1. Remove the Footstand from the

Cisco

IP Phone 7960

To remove the footstand from the IP Phone 7960 to which you

are attaching the 7914

Expansion Module, follow these steps.

Step 1 Unplug the Cisco IP Phone 7960 network and power

connections.