Specifications

Configuring IP Multilayer Switching
Configuring NetFlow Data Export
4
mls active on Vlan10, domain WBU
router#
Monitoring MLS Interfaces for VTP Domains
To show MLS information for a specific VTP domain use the following command in EXEC mode:
After entering this command, you see this display:
router# show mls rp vtp-domain WBU
vlan domain name: WBU
current flow mask: ip-flow
current sequence number: 80709115
current/maximum retry count: 0/10
current domain state: no-change
current/next global purge: false/false
current/next purge count: 0/0
domain uptime: 13:07:36
keepalive timer expires in 8 seconds
retry timer not running
change timer not running
fcp subblock count = 7
1 management interface(s) currently defined:
vlan 1 on Vlan1
7 mac-vlan(s) configured for multi-layer switching:
mac 00e0.fefc.6000
vlan id(s)
1 10 91 92 93 95 100
router currently aware of following 1 switch(es):
switch id 0010.1192.b5ff
Configuring NetFlow Data Export
Note You need to enable NDE only if you will export MLS cache entries to a data collection application.
Perform the task in this section to configure your Cisco router for NDE. To ensure a successful NDE
configuration, you must also configure the Catalyst switch. For a full description, see the Catalyst 5000
Series Multilayer Switching User Guide.
Specifying an NDE Address on the Router
To specify an NDE address on the router, use the following command in global configuration mode:
Command Purpose
Router# show mls rp vtp-domain [domain-name]
Displays MLS interfaces for a specific VTP domain.