Specifications

Configuring IP Multilayer Switching
Configuring and Monitoring MLS
3
• MLS status (enabled or disabled) for switch interfaces and subinterfaces
• Flow mask used by this MLS-enabled switch when creating Layer 3-switching entries for the router
• Current settings of the keepalive timer, retry timer, and retry count
• MLSP-ID used in MLSP messages
• List of interfaces in all VTP domains that are enabled for MLS
After entering this command, you see this display:
router# show mls rp
multilayer switching is globally enabled
mls id is 00e0.fefc.6000
mls ip address 10.20.26.64
mls flow mask is ip-flow
vlan domain name: WBU
current flow mask: ip-flow
current sequence number: 80709115
current/maximum retry count: 0/10
current domain state: no-change
current/next global purge: false/false
current/next purge count: 0/0
domain uptime: 13:03:19
keepalive timer expires in 9 seconds
retry timer not running
change timer not running
fcp subblock count = 7
1 management interface(s) currently defined:
vlan 1 on Vlan1
7 mac-vlan(s) configured for multi-layer switching:
mac 00e0.fefc.6000
vlan id(s)
1 10 91 92 93 95 100
router currently aware of following 1 switch(es):
switch id 0010.1192.b5ff
Monitoring MLS for an Interface
To show MLS information for a specific interface, use the following command in EXEC mode:
After entering this command, you see this display:
router# show mls rp int vlan 10
Command Purpose
Router# show mls rp
Displays MLS details for all interfaces.
Command Purpose
Router# show mls rp [interface]
Displays MLS details for a specific interface.