User guide

Chapter 4. Configuring InfiniBand with QLogic bridges 69
7. Repeat steps 4 through 6 for the other VFx Controller. There are a total of two controllers.
When the driver instillation is complete, you see two SilverStorm VFx I/O Controllers under
SCSI and RAID Controllers in Device Manager as shown in Figure 4-52.
Figure 4-52 VFx Controllers in Device Manager
The VFx Controllers will have exclamation points (!) on them until an SRP mapping is
created. Each bridge module has two IO Controllers (IOC), thus the two VFx controllers in
Device Manager.
8. Open the Web interface of your bridge module. Then, click SRP Initiator Discovery and
Start. The bridge module discovers your InfiniBand HCA and creates four Extended SRP
IDs per HCA port as shown in Figure 4-53. These IDs are later mapped to the remote
drives on the storage target.
Figure 4-53 Discovered SRP Initiators
In this example, only one InfiniBand switch was present in the BladeCenter chassis, so
only one InfiniBand HCA port was available to the bridge module.