User guide

Chapter 4. Configuring InfiniBand with QLogic bridges 55
10.Click Configure to designate a name for the device as shown in Figure 4-27. This name
will be used later when mapping to an SRP Initiator.
Figure 4-27 Assign a name to the storage device
11.After you designate a name, click Submit. The remote drive moves from Discovered
Devices to Configured Devices (Figure 4-28).
Figure 4-28 Configured Storage Device
12.Close the FCP Device Discovery window and click SRP map config on the GUI main
menu page. Here, you see the virtual HBAs listed:
– If your virtual HBA was created on IOC 1, click the Click To Add link under the IOC 1
heading.
– If your virtual HBA was created on IOC 2, click the Click To Add link under the IOC 2
heading.
13.Give the map a name and select a map type, then click Next as shown in Figure 4-29 on
page 56. There are two mapping types:
–
Explicit: In an explicit mapping, the host and target LUN numbers must be listed in the
mapping.
–
Direct: In a direct mapping, the host sees all remote drives that are visible to the port
WWNs without a specific LUN being identified.
You address explicit mapping first, and then direct mapping.