User guide

Chapter 4. Configuring InfiniBand with QLogic bridges 45
7. The installation continues. As shown in Figure 4-5, when prompted to install the
SilverStorm firmware onto the HCA, select n to select no.
Figure 4-5 Do not install SilverStorm firmware
8. Your drivers should now be up to date as shown in Figure 4-6.
Figure 4-6 Driver installation complete
4.1.2 QLogic InfiniBand Ethernet Bridge Module: Configuring VNIC
In this section, we describe how to configure a virtual network interface (VNIC) on a Linux
blade using the QLogic InfiniServ drivers and the QLogic InfiniBand Ethernet Bridge. The
VNIC driver allows you to create up to 84 virtual interfaces per bridge module.
Generating module dependencies...
Updating HCA Firmware ...
Select HCAs to Update:
1) HCA 1 (25208 Rev a0 psid "" Node GUID: 0x0005ad0000050464)
Selection (a for all, n for none) [a]: n
-------------------------------------------------------------------------------
Updating dynamic linker cache...
SilverStorm Technologies Inc. IBM Install (4.1.0.6.3 release) Menu
Please Select Install Actin:
0) IB Network Stack [ Up To Date ] [Available]
1) IB Development [ Up To Date ] [Available]
2) IB Boot [Do Not Install] [Not Avail]
3) Fast Fabric [Do Not Install] [Not Avail]
4) Virtual HBA (SRP) [ Up To Date ] [Available]
5) Virtual NIC [ Up To Date ] [Available]
6) IP over IB [ Up To Date ] [Available]
7) MPI Runtime [Do Not Install] [Not Avail]
8) MPI Development [Do Not Install] [Not Avail]
9) MPI Source [Do Not Install] [Not Avail]
a) uDAPL [ Up To Date ] [Available]
b) SDP [ Up To Date ] [Available]
c) RDS [ Up To Date ] [Available]
P) Perform the selected actions
I) Install All
U) Uninstall All
X) Return to Previous Menu (or ESC)