Installation guide

3-18
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Chapter 3 Installing the IGX
Installing a URM
Step 1 Attach an ESD-preventive wrist strap before handling either the front card or the encryption AIM.
Tip Use the anti-static bag used to ship the URM as a ground cloth to prevent ESD.
Step 2 With the flat-blade screwdriver, remove the three metal screws nearest the AIM connector while holding
down the URM front card.
Step 3 Place the encryption AIM in the plastic stand-off that comes with the encryption AIM.
Step 4 Align the legs on the plastic stand-off with the screw holes on the URM front card and insert the
encryption AIM into the AIM connector on the URM front card (see Figure 3-8).
Note Be sure to firmly seat the encryption AIM in the connector. Also, make sure that the metal
stand-offs align with the screw holes on the URM front card.
Figure 3-8 Encryption AIM Installation on the URM
62309
Metal standoff
AIM
Metal standoffs