Installation guide

Contents
vi
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Making Serial Data Connections 3-33
Configuring the Port Modes of the HDM Back Cards 3-34
HDM and LDM Redundancy 3-35
Configuring the Mode of an LDI Port 3-35
Making Frame Relay Connections 3-36
Maximum Connections per Port with Signaling Protocols 3-37
Setting Up Frame Relay on a UFM 3-37
Y-Cable Redundancy on the UFMs 3-37
Connecting UFM Cabling 3-39
Setting Up Frame Relay Ports and Connections (UFM) 3-39
Commands for T1/E1 Frame Relay 3-40
Deleting a Frame Relay Port 3-40
Setting Up Frame Relay on an FRM 3-41
Port Mode Selection for V.35 and X.21 3-41
Frame Relay Card Redundancy 3-42
Setting Up Frame Relay Ports and Connections (FRM) 3-43
Commands for T1/E1 Frame Relay 3-44
Deleting a Frame Relay Port 3-44
Making Alarm Relay Output Connections 3-45
Setting Up the ARM Card Set 3-45
Making External Clock Connections 3-47
Attaching Peripherals 3-47
Connecting a Single Network Management Station 3-47
LAN Connection for the Network Management Station 3-49
Configuring the LAN Port 3-50
Connecting a Network Management Station to Multiple Networks 3-53
Connecting the Printer 3-53
Connecting a Modem 3-54
Connecting the Power Supply Monitor 3-55
Using the Power Supply Monitor Connector 3-55
Initial Startup of the IGX 3-56
NPM Startup Diagnostic Test 3-57
Card Self-Test 3-58
Inspecting Status Lights 3-58
Checking the Power Supplies (AC Systems) 3-59