Installation guide

Contents
v
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Making Power and Ground Connections 2-35
Making the Frame Bonding (Ground) Connection 2-35
Cisco Cabinet Connections 2-36
Standalone Cabinet Connections 2-36
AC Power Connections 2-39
DC Power Connections 2-41
Where to Go Next 2-48
CHAPTER 3 Installing the IGX 3-1
Preparing the Cards 3-1
Tools and Equipment 3-2
Inserting the Cards 3-8
Making Signal Connections 3-9
Connecting Trunks 3-10
Setting Up a UXM-E 3-10
Bringing Up a UXM-E Trunk 3-10
Inverse Multiplexing over ATM on Trunks 3-13
Adding an IMA Feeder Trunk 3-13
Adding Links to an IMA Feeder Group 3-14
Removing Links from an IMA Feeder Group 3-14
UXM-E Inverse Multiplexing ATM IMA Lines 3-14
Bringing Up a UXM-E in UNI or NNI Port Mode 3-15
Connecting an NTM T1 or Y1 Trunk 3-16
Connecting an NTM E1 or Subrate Trunk 3-17
Installing a URM 3-17
Installing the Encryption Advanced Interface Module 3-17
Configuring Internet Encryption 3-19
Configuring Internet Key Exchange Security Protocol 3-20
Configuring IPSec Network Security 3-20
Installing Voice Cards 3-25
Connecting a CVM to a T1 or J1 Line 3-26
Connecting a CVM to an E1 Line or a Subrate Trunk 3-26
TDM Transport on the CVM 3-27
Connecting a UVM to T1 Lines 3-28
Connecting a UVM to E1 Lines 3-30
Connecting a UVM to J1 Lines 3-31