Installation guide

2-17
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Chapter 2 Preparing to Install
IGX 8410 Enclosure Installation
Figure 2-5 Rack-Mount Cabinet
Step 6 This step requires one person on each side of the IGX card cage. Lift and slide the card cage into the
rack at the front of the rack. Slide the IGX 8410 node to the back and rest the rear of the system on the
temporary mounting brackets and spacer.
Step 7 Secure the front bracket (or mid-mount bracket) to the rack. The mid-mount brackets require the
threaded rolling screws that the IGX 8410 kit includes. Attach the IGX 8410 node to the rack with eight
#10-32 machine screws.
Caution Make sure that mounting the equipment does not create a hazardous condition due to uneven mechanical
loading. The equipment rack should be securely supported.
Step 8 Attach the permanent rear mounting brackets to the rack.
Step 9 Remove the temporary mounting brackets and temporary spacer bracket.
Step 10 If this is a DC-powered system, go to the “DC Power Connections” section on page 2-41.
Step 11 Go to the procedures in Chapter 3, “Installing the IGX.”
Optional
mid mount
bracket
Back
mounting
bracket
Mounting
bracket
System
status LEDs
Door
Air intake
grille
Front mounting
bracket
H8384