Installation guide

2-16
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Chapter 2 Preparing to Install
IGX 8410 Enclosure Installation
Figure 2-4 Temporary Spacer Bracket and Mounting Bracket
Step 3 Position the IGX 8410 node in front of the cabinet. This position should be such that the back of the
IGX card cage faces the front of the rack. If you have not already done so, remove the foam strips from
the sides, front, and back.
Step 4 Remove the attached mounting brackets (filler plates) for the standalone version. The mounting brackets
for the rack-mount go in these places. See Figure 2-5 for the locations of the mounting brackets.
Step 5 Attach the front mounting brackets to the IGX 8410 node.
Caution An IGX 8410 node requires two or three people to lift it into the rack.
H8383
Temporary
spacer bracket
Mounting bracket