Installation guide

A-26
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Appendix A System Specifications
Cabling Summary
Cabling Summary
Note EIA/TIA-232 and EIA/TIA-449 existed as recommended standards RS-232 and RS-449 before the
Electronics Industries Association (EIA) and Telecommunications Industry Association (TIA) accepted
them as standards.
Warning To prevent accidental discharge in the event of a power line cross, route on-premise wiring away
from power cables and off-premise wiring, or use a grounded shield to separate the on-premise
wiring from the power cables and off-premise wiring. A power line cross is an event, such as a
lightning strike, that causes a power surge. Off-premise wiring is designed to withstand power line
crosses. On-premise wiring is protected from power line crosses by a device that provides
overcurrent and overvoltage protection. Nevertheless, if the on-premise wiring is in close proximity
to, or not shielded from, the off-premise wiring or power cables during a lightning strike or power
surge, the on-premise wiring can carry a dangerous discharge to the attached interface, equipment,
and nearby personnel. To see translations of this warning, refer to the Regulatory Compliance and
Safety Information document that accompanied this product.
UXM-E Cabling
The cabling for the UXM-E appears in Table A-9.
Table A-9 UXM-E Cabling
Model Number Description
CAB-SMF-Y-SC Single mode fiber Y-cable with SC male connectors
CAB-T3E3-PL-Y SMB-BNC Y-cable, Posi-Lok SMB female connector
on Y end and BNC female connector on tail end
CAB-T3E3-PL-Y-6 Bundle of 6 SMB-BNC Y-cable
CAB-T3E3-PL-Y-12 Bundle of 12 SMB-BNC Y-cable
CAB-SMF-SC-x Standard single mode fiber cable with SC male
connectors, x ft = 10, 25, 50, 75, 100
CAB-MMF-SC-x Standard MMF cable with SC male connectors, x ft =
10, 25, 50, 75, 100
CAB-T3E3-PL-AD SMB-BNC adaptor cable 72 inch
CAB-T3E3-PL-AD-6 Bundle of 6 SMB-to-BNC adaptor cable
CAB-T3E3-PL-AD-12 Bundle of 12 SMB-to-BNC adaptor cable
CAB-5607-10= DB-15/Y Cable/M15-F15 10 ft
CAB-5614-x T1/M15-M15 Xover, x ft = 10, 25, 50, 75, 100
CAB-5616-x T1/M15-M15, x ft = 10, 25, 50, 75, 100
CAB-5685-10= E1/Y Cable 10 ft