Installation guide

5-10

Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases

OL-1165-06

Chapter 5 Replacing Parts on the IGX

Replacing an AC Power Supply

Step 7 Loosen the captive screw at the front bottom of the power supply. See Figure 5-5.

Step 8 Move the supply slightly out, then reseat it and tighten the captive screw. This resets the supply’s

internal power-monitoring circuit.

Step 9 Check the supply-monitoring circuit on the SCM. First, enter the resetcd 0 command at the control

terminal (this resets the power supply monitor on the SCM). After waiting about 10 seconds or more,

enter the dsppwr command and see if the FAIL indicator for the supply comes on again. Note which

power supply has failed.

Figure 5-5 875-Watt Power Supply

Note If the DC and AC okay LEDS do not come on or the dsppwr command still indicates a failure,

proceed with the replacement.

Step 10 Loosen the captive screw that secures a supply to the power supply tray.

Step 11 Pull out the power supply with one hand on the handle and one hand under the supply.

DC okay LED

AC okay LED

Handle

Captive screw

H8341