Installation guide

3-60
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Chapter 3 Installing the IGX
IGX Configuration Summary
• For setting up voice lines:
– Activate the line (using the upcln or upln commands).
– Configure the line (using the cnfln command).
– Configure redundancy (using the addyred command).
• For setting up data lines and ports:
– Activate the line (using the upcln command).
– Configure the line (using the cnfcln command).
– Configure redundancy (using the addyred command).
• For setting up Frame Relay lines and ports. (See the “Setting Up Frame Relay Ports and Connections
(UFM)” section on page 3-39 for a description.)
– Activate each port (using the upfrport command).
– Specify a mode for the card as needed if the card is a UFM-U (using the cnfmode command).
To determine the current mode of a particular UFM-U, use the dspmode command.
• For setting up ATM lines and ports:
– Activate the line (using the upln command).
– Configure the line (using the cnfln command).
– Activate the ports (using the upport command).
– Configure the ports (using the cnfport command).
– For a UXM-E, specify cellbus bandwidth as needed (using the cnfbusbw command).
• For setting up voice connections:
– Add the connections (using the addcon command).
– Configure connection parameters (using the cnfvchadv, cnfchdl, cnfchec, cnfchgn, cnfcond,
cnfcondsc, cnfrcvsig, cnfsmtsig, cnfvchtp, and cnfchutl commands).
– For only the UVM, additional configuration commands include cnfuvmchparm, cnfchfax, and
cnflnpass. (Use the dsplncnf command to check whether the port is configured for External,
Pass-through, Blocking, or Inserting.)
• For setting up data connections:
– Add the connections (using the addcon command).
– Configure connection parameters (using the cnfdclk, cnfcldir, and cnfict commands).
• For setting up Frame Relay connections:
– Add the connections (using the addcon command).
– Configure connection classes (using the cnfcls command).
– Configure control templates, channel utilization, and channel priorities (using the cnfict,
cnfchutl, and cnfchpri commands).
• For setting up ATM connections (see also the paragraph that follows this list for information on
connections using ATM-to-Frame Relay interworking):
– Add connections (using the addcon command).
– Configure a connection type (using the cnfcontyp command).
• Optimize network routing and bandwidth (using the cnfchutl, cnfpref, cnfcos commands).