Manualshelf

Installation guide

ManualsBrandsCisco ManualsComputer equipmentIGX 8400 Series
131132133134135136137138139140
3-53
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Chapter 3 Installing the IGX
Attaching Peripherals
Figure 3-20 SV+ LAN Connection to an IGX Node (No Gateway)
Step 6
Switch on the control terminal (or Cisco WAN Manager workstation). Adjust the terminal’s
configuration, if necessary, to match the default settings of the control terminal port in the IGX node.
See Cisco WAN Manager Operations for settings and operating instructions for the workstations.
Connecting a Network Management Station to Multiple Networks
When a network management station has more than one serial port, ports can connect to different
networks. When the number of workstation serial ports is less than the number of networks to be
managed, a terminal server is necessary to obtain a communications link to the separate networks. This
subject is covered in the Cisco WAN Manager Installation publication.
Connecting the Printer
At least one node in the network should have a printer connected. The printer connects to the AUX port
on the SCM.
The printer is used to print information about network operation. It can be configured to print
maintenance information on a regular basis, and it can print specific diagnostic information when
necessary. Instructions on using the printer for this purpose are in the Cisco WAN Switching Command
Reference.
Attach the printer to the IGX node as follows:
Step 1 Check the printer EIA/TIA-232/V.24 cabling pinout and, if required, adjust the DIP switches to the
settings indicated for the type of printer to be connected to the IGX node. See Appendix A, “System
Specifications” for EIA/TIA-232/V.24 cable pinout and DIP switch settings.
Step 2 At the back of the cabinet, run the printer EIA/TIA-232/V.24 cable through the opening at the bottom
and up to the SCM card in back slot 1.
Step 3 Locate the AUX port connector on the SCM and attach the printer EIA/TIA-232/V.24 cable to it. See
Figure 3-21.
Note: IP numbers are representative only.
SCM
SV+
AUI
192.187.207.30
192.187.207.200
H8375