Installation guide

ManualsBrandsCisco ManualsComputer equipmentIGX 8400 Series

131

132

133

134

135

136

137

138

139

140

3-51

Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases

OL-1165-06

Chapter 3 Installing the IGX

Attaching Peripherals

A cnflan command screen looks like this:

D2.cb1 LAN superuser IGX 8410 9.3 Feb. 27 2000 14:23 PST

Active IP Address: 192.187.207.21

IP Subnet Mask: 255.255.255.0

TCP Service Port: 5130

Default Gateway IP Address: 192.187.207.1

Maximum LAN Transmit Unit: 1500

Ethernet Address: 00.55.43.00.04.55

Control Socket - Ready

Base Socket Descriptor - 1

Socket Closed

Last Command: cnflan

Next Command:

The active IP address for the workstation has been entered as the IP address selected previously for the

node, 192.187.207.21. The IP Subnet mask is entered as 255.255.255.0 for a Class C LAN network. The

TCP service port is entered as 5120. Because the workstation and node are on different networks in this

example, a gateway address of 192.187.207.1 has been entered. If the workstation and node are both on

the same network, no gateway address is needed. The “Maximum LAN Transmit Unit” and “Ethernet

Address” parameters are not configurable by the cnflan command. The Ethernet Address is a hardware

address (burned into the NPM card) that is unique to each NPM card.

Step 4 Connect the Cisco WAN Manager workstation and the IGX node to a LAN network. Examples are

shown in Figure 3-19 and Figure 3-20. The LAN port on the IGX node provides a DB-15 connector that

can be connected to a Y-cable, which in turn is connected to an AUI, as shown in Figure 3-20.

Step 5 To make sure that a LAN connection on the IGX LAN port is good, use a sample host name of “sanfran”

entered in the config.sv file, and enter the following at the Cisco WAN Manager workstation:

ping sanfran

After the workstation and IGX node interface have been set up, Cisco WAN Manager can be started.

After Cisco WAN Manager has started and the communication sockets are active, the dsplan command

screen looks like this:

D2.cb1 LAN cisco IGX 8410 9.3 Feb. 27 2000 14:27 PST