Installation guide

3-25
Cisco IGX 8400 Series Installation Guide, Release 9.3.3 and Later Releases
OL-1165-06
Chapter 3 Installing the IGX
Installing Voice Cards
interface Serial1/0:0
bandwidth 1472
ip address 10.6.6.2 255.0.0.0
no ip directed-broadcast
encapsulation ppp
no ip route-cache
load-interval 30
no fair-queue
crypto map cmap
!
interface Serial1/0:1
no ip address
no ip directed-broadcast
fair-queue 64 256 0
!
interface Serial1/1:0
no ip address
no ip directed-broadcast
!
interface Serial1/1:1
no ip address
no ip directed-broadcast
fair-queue 64 256 0
!
router rip
network 3.0.0.0
network 6.0.0.0
!
ip classless
ip route 0.0.0.0 0.0.0.0 172.16.0.1
no ip http server
!
access-list 101 deny udp any eq rip any
access-list 101 deny udp any any eq rip
access-list 101 permit ip 10.6.6.0 0.0.0.255 10.6.6.0 0.0.0.255
!
line con 0
exec-timeout 0 0
transport input none
line aux 0
line vty 0 4
login
!
!
end
Installing Voice Cards
This section describes how to install the voice cards. See the “IGX Configuration Summary” section on
page 3-59 for a summary of the commands that apply to circuit lines and voice connections. The two
voice card sets are the channelized voice module (CVM) and the universal voice module (UVM). These
cards can also carry channelized data. The serial data card sets are the high-speed data module (HDM)
and the low-speed data module (LDM). This section also describes the considerations for using the
Time-Division Multiplexing (TDM) Transport feature on the CVM.