Specifications

10-58
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 10 Cisco IGX 8400 Series IP Service
IP Service Provisioning
Step 6 To view partition configurations on an interface, use the switch software command, dsprsr (see
Example 10-5).
Example 10-5 Sample dsprsr Output
sanjose TN Cisco IGX 8430 9.3.10 July 31 2000 20:29 PST
Line : 6.6
Maximum PVC LCNS: 256 Maximum PVC Bandwidth: 48000
(Reserved Port Bandwidth: 150)
State MinLCN MaxLCN StartVPI EndVPI MinBW MaxBW
Partition 1: E 0 100 2 10 0 48000
Partition 2: D
Partition 3: D
Step 7 To see Qbin configuration information, use the switch software command, dspqbin (see Example 10-6).
Example 10-6 Sample dspqbin Output
n4 TN SuperUser IGX 15 9.3 March 4 2000 16:48 PST
Qbin Database 3.1 on UXM qbin 10
Qbin State: Enabled
Minimum Bandwidth: 0
Qbin Discard threshold: 65536
Low CLP threshold: 95%
High CLP threshold: 100%
EFCI threshold: 40%
Last Command: dspqbin 3.1 10
Next Command:
Step 8 If an interface is present but not enabled, perform the previous debugging steps for the interface.
Step 9 Use the Cisco IOS ping command to send a ping over the label switch connections. If the ping does not
work, but all the label switching and routing configuration appear correct, check that the LSC has found
the VSI interfaces correctly by entering the following Cisco IOS command on the LSC:
If the interfaces are not shown, recheck the configuration of port 3.1 on the IGX switch as described in
the previous steps.
Step 10 If the VSI interfaces are shown but are down, check whether the LSRs connected to the IGX switch show
that the lines are up. If not, check such items as cabling and connections.
Command Description
Router LSC1# show mpls interfaces Shows the label interfaces.