Specifications

10-56
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 10 Cisco IGX 8400 Series IP Service
IP Service Provisioning
Checking the IGX Extended ATM Interfaces
Use the following procedure to test the label switching configuration on the IGX switch (ATM LSR-1,
for example):
Step 1 Check whether the controller recognizes the interfaces correctly; on LSC1, for example, enter the
following command:
The sample output for ATM-LSC-1 (Cisco IGX 8410, 8420, and 8430 shelves) is:
Phys desc: 3.1
Log intf: 0x00040100 (0.4.1.0)
Interface: slave control port
IF status: N/A IFC state: ACTIVE
Min VPI: 0 Maximum cell rate: 10000
Max VPI: 10 Available channels: xxx
Min VCI: 0 Available cell rate (forward): xxxxxx
Max VCI: 65535 Available cell rate (backward): xxxxxx
Phys desc: 3.3
Log intf: 0x00040200 (0.4.2.0)
Interface: ExtTagATM13
IF status: up IFC state: ACTIVE
Min VPI: 0 Maximum cell rate: 10000
Max VPI: 10 Available channels: xxx
Min VCI: 0 Available cell rate (forward): xxxxxx
Max VCI: 65535 Available cell rate (backward): xxxxxx
Phys desc: 4.2
Log intf: 0x00040300 (0.4.3.0)
Interface: ExtTagATM22
IF status: up IFC state: ACTIVE
Min VPI: 0 Maximum cell rate: 10000
Max VPI: 10 Available channels: xxx
Min VCI: 0 Available cell rate (forward): xxxxxx
Max VCI: 65535 Available cell rate (backward): xxxxxx
-------
Tip Check online documentation for the most current information. For information on accessing related
documents, see the “Accessing User Documentation” section on page xii.
Step 2 If there are no interfaces present, first check that card 3 is active and available with the switch software
command, dspcds. If the card is not active and available, reset the card with the switch software
command, resetcd. Remove the card to reset if necessary.
Command Description
Router LSC1# show controllers VSI descriptor
Shows VSI information for extended ATM interfaces.