Specifications

10-50
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 10 Cisco IGX 8400 Series IP Service
IP Service Provisioning
Step 3
Configure VSI partitions on the UXM interfaces:
cnfrsrc 6.1 256 26000 y 1 e 512 1500 240 255 26000
105000
or if entered individually:
cnfrsrc 6.1
256 {PVC LCNs, accept default value}
26000
y {to edit VSI parameters}
1 {partition}
e {enable partition}
512 {VSI min LCNs}
1500 {VSI max LCNs}
240 {VSI starting VPI}
255 {VSI ending VPI}
26000 {VSI min bandwidth}
105000 {VSI max bandwidth}
—
Step 4
Repeat for UXM interfaces 6.2 and 7.1.
cnfrsrc 3.2 256 26000 y 1 e 512 1500 240 255 26000
105000
cnfrsrc 4.1 256 26000 y 1 e 512 1500 240 255 26000
105000
—
Step 5
Enable MPLS queues on UXM:
dspqbin 6.1 10
and verify that it matches the following:
Qbin Database 6.1 on UXM qbin 10
Qbin State: Enable
Qbin discard threshold: 65536
EPD threshold: 95%
High CLP threshold: 100%
EFCI threshold: 40%
If configuration is not correct, enter
cnfqbin 6.1 10 e n 65536 95 100 40
MPLS CoS uses Qbins 10-14.
Step 6
Repeat as necessary for UXM interfaces 3.2 and 4.1:
cnfqbin 3.2 10 e n 65536 95 100 40
cnfqbin 4.1 10 e n 65536 95 100 40
See description for Step 5.
Step 7
Enable the VSI controller interface:
addctrlr 6.1 vsi 1 1 100 200
The first “1” after “vsi” is the vsi controller ID,
which must be set the same on both the IGX and
the LSC. The default controller ID on the LSC is
“1.”
The second “1” after “vsi” is the partition ID that
indicates this is a controller for partition 1.
Command Description