Specifications

10-35
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 10 Cisco IGX 8400 Series IP Service
IP Service Provisioning
Step 4 Using the switch software command addctrlr, add a controller.
Note The switch software command addctrlr, only supports MPLS and generic VSI controllers that
do not require support for the AnnexG protocol.
Tip The switch software command addctrlr, requires you to specify a controller ID, a unique identifier
between 1 and 16. Different controllers must be specified with different controller IDs.
Step 5 Assign ATM CoS template to an interface (ATM services only—see Chapter 8, “ATM
Service—Functional Overview”).
Step 6 Add a slave (for more information on VSI masters and slaves, see “VSI Masters and Slaves”).
Step 7 Configure slave redundancy (UXM and UXM-E only).
Tip The URM does not support hot slave redundancy. For the URM, warm redundancy must be configured
by setting up redundant partitions. See MPLS Label Switch Controller and Enhancements 12.2(8)T.
Step 8 Use the switch software command, dspctrlrs, to display your controller configuration.
Step 9 Manage your resources.
Tip Use dspctrlrs to display all VSI controllers attached to the IGX. Use delctrlr to delete a controller from
the IGX.
Note MPLS controllers serving as an interface shelf are designated as Label Switch Controllers (LSCs).
Start VPI 0-255 (UNI)
0-4095 (NNI)
Note The URM does not
support NNI.
0 Specifies the initial interface for the
selected partition.
End VPI 0-255 (UNI)
0-4095 (NNI)
Note The URM does not
support NNI.
0 Specifies the final interface for the selected
partition.
Min Bw 0-maximum line rate 0 Specifies the minimum bandwidth available
for the selected partition.
Max Bw 0-maximum line rate 0 Specifies the maximum bandwidth
available for the selected partition.
Table 10-10 cnfrsrc Command Parameters (continued)
Parameter
(Object) Name Range/Values Default Description