Specifications

10-33
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 10 Cisco IGX 8400 Series IP Service
IP Service Provisioning
Note Use FRF.8 SIW transparent mode for VoATM connections, and use FRF.8 SIW translational mode for
VoIP and data connections.
IP Service Provisioning
You can provision IP services of varying complexities on the IGX using the URM card.
If you want to use the URM as an in-chassis router for VoIP or VoATM, see CARDS for basic URM
setup and the Cisco IOS software documentation supporting the Cisco IOS software being used on the
URM.
If you want to use the URM as an in-chassis router with IPsec-VPN capabilities, see the “Installing the
Encryption Advanced Interface Module” section on page 3-17 in the Cisco IGX 8400 Series
Installation Guide for information on installing the correct AIM module for VPN. For information on
configuring IPSec, refer to Cisco IOS documentation, as listed in the “Cisco IOS Software
Documentation” section on page ix.
The following sections describe how to set up the IGX switch for use with external controllers,
preparatory to configuring the IGX for MPLS. For information on configuring MPLS on the IGX, see
the “MPLS Configuration on the IGX” section on page 10-42. For information on configuring
MPLS-VPNs on the IGX, see the “MPLS VPN Sample Configuration” section on page 10-59.
Tip For additional Cisco IOS features supported on the IGX, see the release notes document for the
Cisco IOS software release you intend to use on the URM.
Cisco IGX CVM — NN
Cisco IGX HDM — NN
Cisco IGX LDM — NN
Cisco MGX VISM — YN
Cisco MGX RPM — NY
Cisco MGX FRSM FR Y FRF.8 SIW Y FRF.8 SIW
Cisco MGX FRSM FST N Y FRF.8 SIW
Cisco MGX AUSM CBR Y Y
Cisco MGX AUSM VBRrt Y Y
Cisco MGX AUSM VBRnt Y Y
Cisco MGX AUSM ABR N Y
Cisco MGX AUSM UBR N Y
Cisco MGX AUSM FST N Y
Table 10-9 Connections Supported on the URM (continued)
Hardware Platform
Connection
Endpoint Connection Type Voice Connection Data Connection