Specifications

9-7
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 9 Cisco IGX 8400 Series Frame Relay Service
Switch Software Commands Related to Frame Relay Connections
Step 4 For V.35 and X.21 interfaces, check the mode (DCE or DTE) of each relevant port by using the
dspfrport command. (For T1 and E1 lines, the mode is not applicable.) On an FRI-X.25 or FRI-V.35
back card, a jumper board near each connector determines the mode of the port. See the Port Mode
Selection for V.35 and X.21 section on page 9-5.
Step 5 For optional Y-cable redundancy, configure the two slots for redundancy by using the addyred
command. For V.35 and X.21 interfaces, go to Step 8.
Step 6 For T1, E1, and J1 interfaces, bring up the line using the upln command.
Step 7 For T1, E1, and J1 interfaces, configure the line using the cnfln command.
Step 8 For T1, E1, and J1 interfaces, add the logical FR port using the addport command.
Step 9 Activate the port using the upport command.
Step 10 Configure the port for speed, clocking, LMI type, and so on, by using the cnfport command.
Alternatively, you can keep the default parameters.
Step 11 Determine which FR class number to use when you add connections to a port. To see the parameters that
a class specifies, use the dspcls command. To modify parameters in a class, use the cnfcls.
Step 12 Add connections to the port by using the addcon command. Enter the slot number and specify a DLCI
for each end of the connection.
Step 13 For an individual connection, you can configure bandwidth parameters or enable ForeSight (if
purchased) by using the cnffrcon.
Step 14 Optionally, you can set the channel priority by using the cnfchpri command. Normally, the
system-default priority is adequate.
Switch Software Commands Related to Frame Relay
Connections
Full command descriptions for the switch software commands listed in Table 9-2 can be accessed at one
of the following links:
For commands addad through cpytrkict, see Chapter 3, Alphabetical List of Commands addad
through cpytrkict in the Cisco WAN Switching Command Reference.
For commands dchst through window, see Chapter 4, Alphabetical List of Commands dchst
through window in the Cisco WAN Switching Command Reference.
Table 9-2 Switch Software Commands Related to Frame Relay Connections
Command Description
addcon Adds a connection
addport Add Frame Relay port
cnfchpri Configure channel priority
cnffrcls Configure Frame Relay class
cnffrcon Configure Frame Relay connection
cnfict Configure interface control template
cnfmode Configure mode