Specifications

8-9
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 8 Cisco IGX 8400 Series ATM Service
Switch Software Commands Related to ATM Service
Timesaver Use connection classes as templates for configuring multiple ATM connections. If a suitable connection
class is not configured, use the cnfcls command to modify the connection class most like the one you
want to apply to your connection.
Step 9 Configure the desired connection onto the port with the switch software addcon command.
Tip For connections with both endpoints on UXM-Es or BXMs, switch software will prompt you to enable
or disable trunk cell routing restrictions. By restricting a connection between UXM-Es to trunk cell
routing, switch software prevents ATM cells from passing over a FastPacket trunk.
Switch Software Commands Related to ATM Service
Full command descriptions for the switch software commands listed in Table 8-3 can be accessed at one
of the following links:
• For commands addad through cpytrkict, see Chapter 3, “Alphabetical List of Commands addad
through cpytrkict” in the Cisco WAN Switching Command Reference.
• For commands dchst through window, see Chapter 4, “Alphabetical List of Commands dchst
through window” in the Cisco WAN Switching Command Reference.
Table 8-3 Switch Software Commands Related to ATM Connections
Command Description
addcon Adds the specified connection.
addport Adds the specified ATM port.
clrchstats Clears channel statistics.
cnfatmcls Configures an ATM class template.
Note An ATM class template differs from the SCT
used in configuring VSIs.
cnfcls Configures a class template.
cnfcon Configures the specified connection.
cnfport Configures the specified port.
cnfportq Configures the ARM port queue.
delcon Deletes the specified connection.
delport Deletes the specified ATM port.
dnport Deactivates (downs) the specified port.
dspatmcls Displays the ATM class for the specified port.
dspchstats Displays the channel statistics.
dspcls Displays the class template.
dspcon Displays information for the specified connection.