Specifications

6-5
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 6 Cisco IGX 8400 Series Data Service
Switch Software Command Related to Data Service
Switch Software Command Related to Data Service
Full command descriptions for the switch software commands listed in Table 6-2 can be accessed at one
of the following links:
• For commands addad through cpytrkict, see Chapter 3, “Alphabetical List of Commands addad
through cpytrkict” in the Cisco WAN Switching Command Reference.
• For commands dchst through window, see Chapter 4, “Alphabetical List of Commands dchst
through window” in the Cisco WAN Switching Command Reference.
Where to Go Next
For information on IGX voice service, refer to Chapter 7, “Cisco IGX 8400 Series Voice Service”
For installation and basic configuration information, see the Cisco IGX 8400 Series Installation Guide,
Chapter 1, “Cisco IGX 8400 Series Product Overview”
For more information on switch software commands, refer to the Cisco WAN Switching Command
Reference, Chapter 1, “Command Line Fundamentals.”
Table 6-2 Switch Software Commands Related to Data Connections
Command Description
addcon Adds a connection to the specified line.
cnfchdfm Configures data frame multiplexing (DFM) onto a channel.
cnfcheia Configures EIA onto a channel.
cnfcldir Configures control lead direction onto a channel.
cnfdclk Configures data clock for a channel.
cnfict Configures the interface control template.
cpyict Copies the interface control template.
delcon Deletes a connection from a line.
dspbob Displays the breakout box.
Tip Use dspbob to view control lead states for a data channel.
dspcd Displays information for the specified card.
Tip Use dspcd to view the DTE or DCE nature of each data interface
on a specific data card.
dspchcnf Displays the channel configuration for the specified channel.
dspcon Displays information for the specified connection.
dspcons Displays information for all connections on the node.
dspict Displays the interface control template.
prtchcnf Prints the channel configuration.
prtcons Prints all connections on the node.
prtict Prints the interface control template.