Specifications

2-115
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
Where To Go Next
Where To Go Next
For information on IGX nodes, refer to Chapter 3, “Cisco IGX 8400 Series Nodes”
For installation and basic configuration information, see the Cisco IGX 8400 Series Installation Guide,
Chapter 1, “Cisco IGX 8400 Series Product Overview”
For more information on switch software commands, refer to the Cisco WAN Switching Command
Reference, Chapter 1, “Command Line Fundamentals.”
dsprtr (URM only) Displays embedded router configuration information for the
specified slot.
dsprtrcnfdnld (URM only) Displays the download status for the Cisco IOS configuration
file during RRC.
dsprtrslot (URM only) Displays operational information for the embedded router in the
specified slot.
dsprtrslots (URM only) Displays embedded router information for all URMs in the
node.
dsptrks Displays all trunks on the node.
dspyred Displays Y-cable redundancy information for the card in the specified slot.
loadrev Loads a downloaded switch software image into the DRAM on an inactive
NPM.
resetcd Resets the card.
runrev Loads a downloaded switch software image into the DRAM on the active
NPM.
switchcc Cycles redundant NPMs.
tstcon Tests the connection.
tstdelay Verifies connection continuity and measures roundtrip delay of user data on
the specified connection.
tstport Tests the specified port.
upcd Activates (ups) the card in the specified slot.
upcon Activates (ups) a connection on the specified line.
upln Activates (ups) a line on the card in the specified slot.
upport Activates (ups) a port on the specified line.
uptrk Activates (ups) a trunk on the card in the specified slot.
vt Make a virtual connection with a remote node.
Table 2-63 Switch Software Commands Related to Cards (continued)
Command Description