Specifications

2-114
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
Switch Software Command Related to Cards
Switch Software Command Related to Cards
Full command descriptions for the switch software commands listed in Table 2-63 can be accessed at
one of the following links:
• For commands addad through cpytrkict, see Chapter 3, “Alphabetical List of Commands addad
through cpytrkict” in the Cisco WAN Switching Command Reference.
• For commands dchst through window, see Chapter 4, “Alphabetical List of Commands dchst
through window” in the Cisco WAN Switching Command Reference.
Table 2-63 Switch Software Commands Related to Cards
Command Description
addalmslot Adds an ARM to the specific slot.
addextlp Adds an external loop, placing an external device within the loop.
addloclp Adds a local loop to the specified port for troubleshooting.
addrmtlp Adds a remote loop to the specified port for troubleshooting.
addyred Adds Y-cable redundancy to the card in the specified slot.
burnfwrev Copies a downloaded firmware image from the NPM to the specified cards.
burnrtrrcnf (URM only) Copies the Cisco IOS configuration file from the NPM to the
Admin Flash on the URM.
clrrtrcnf (URM only) Clears previous Cisco IOS configuration files from the memory
on the NPM.
cnfleadmon (for data cards) Configures the lead monitor for the node.
cnfmode (UFM only) Configures the mode (see the “Universal Frame Module”
section on page 2-50).
cnfnodeparm Configures node parameters (see Chapter 3, “Cisco IGX 8400 Series
Nodes”).
cnfrtr (URM only) Configures the location from which the embedded router loads
the Cisco IOS configuration.
cnfrtrcnfmastip (URM only) Configures the TFTP service IP address authorized for
Cisco IOS image download in RRC (see the “Initial URM Configuration
Using RRC” section on page 2-96).
cnfrtrparm (URM only) Configures service-level parameters for the embedded router.
cnftstparm Configures card self-test for the specified card types.
delalmslot Deletes the ARM in a specific slot.
dellp Deletes the loopback on the specified port or connection.
delyred Deletes Y-cable redundancy from the card in the specified slot.
dspcd Displays information for the card installed in the specified slot.
dspcds Displays information for all cards installed in the IGX chassis.
dspdnld Displays the progress of a switch software or firmware image download.
dsplns Displays all lines on the node.
dsprevs Displays the switch software image currently loaded into the DRAM on the
active NPM.