Specifications

2-107
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
Universal Router Module
call rsvp-sync
!
!
!
!
!
controller T1 2/0
!
controller T1 2/1
!
!
interface ATM0/0
no ip address
no atm ilmi-keepalive
!
interface FastEthernet1/0
no ip address
shutdown
duplex auto
speed auto
!
interface FastEthernet1/1
no ip address
shutdown
duplex auto
speed auto
!
ip classless
no ip http server
!
!
dial-peer cor custom
!
!
!
!
line con 0
transport input none
line aux 0
line vty 0 4
!
end
Router#
Router#
Configuring URM Connections
Each URM receives a default bandwidth from the Cisco IGX at power on. You can configure this default
bandwidth by using the switch software CLI command, cnfbusbw. For more information on this and
other switch software commands, refer to the Cisco WAN Switching Command Reference.
Note Except for slots 1 and 2 (which are reserved for the NPM), all slots in the IGX can be used to support a
URM. However, the total number of UBUs allocated to all cards supported in the IGX cannot exceed the
total IGX backplane bandwidth.