Specifications

2-105
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
Universal Router Module
Compiled Wed 24-Jan-01 12:29 by yiyan
Image text-base: 0x60008960, data-base: 0x6113E000
cisco URM (R527x) processor (revision 01) with 57344K/8192K bytes of memory.
Processor board ID
R527x CPU at 225Mhz, Implementation 40, Rev 10.0
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
URM image loaded from flash (controlled by "cnfrtrparm" on IGX)
URM booting with BLANK configuration (controlled by "cnfrtr" on IGX)
Front card type: URM Main Board
Back card type: URI-2FE2V
2 FastEthernet/IEEE 802.3 interface(s)
1 ATM network interface(s)
2 Channelized T1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
123K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
8192K bytes of processor board Boot flash (Device not programmable)
Establishing interprocessor communication...done
IGX slot number 15
Boot flash programmed Read/Write from IGX
SETUP: new interface FastEthernet1/0 placed in "shutdown" state
SETUP: new interface FastEthernet1/1 placed in "shutdown" state
Press RETURN to get started!
00:00:18: %LINK-3-UPDOWN: Interface FastEthernet1/0, changed state to up
00:00:18: %LINK-3-UPDOWN: Interface FastEthernet1/1, changed state to up
00:00:19: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/0, changed state to down
00:00:19: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/1, changed state to down
00:00:24: %LINK-3-UPDOWN: Interface ATM0/0, changed state to up
00:00:25: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/0, changed state to up
00:00:32: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/0, changed state to up
00:00:50: %LINK-5-CHANGED: Interface FastEthernet1/0, changed state to administratively down
00:00:50: %LINK-5-CHANGED: Interface FastEthernet1/1, changed state to administratively down
00:00:51: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (URM-IS-M), Version 12.1(5)YA, RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/cgi-bin/ibld/view.pl?i=support
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Wed 24-Jan-01 12:29 by yiyan
00:00:51: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/0, changed state to down
00:00:51: %IP-5-WEBINST_KILL: Terminating DNS process
00:00:54: %DSPRM-5-UPDOWN: DSP 15 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 7 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 8 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 9 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 10 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 11 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 12 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 13 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 14 in slot 2, changed state to up
00:00:55: %DSPRM-5-UPDOWN: DSP 0 in slot 2, changed state to up
00:00:55: %CONTROLLER-5-UPDOWN: Controller T1 2/0, changed state to up
00:00:55: %CONTROLLER-5-UPDOWN: Controller T1 2/1, changed state to up
Router>
Router>
Router>