Specifications

2-98
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
Universal Router Module
Tip The card does not reset after copying the Cisco IOS configuration file from the NPM to the Admin Flash
on the URM. If you want the card to run the copied Cisco IOS configuration file, reset the card with the
switch software rstrtr or resetcd commands.
Step 10 Verify the name and size of the Cisco IOS configuration file located in the admin Flash on the URM
with the switch software dsprtrslot slot command.
Step 11 Configure the embedded router to load the Cisco IOS configuration file from the admin Flash on the
URM with the switch software command, cnfrtr slot a.
Step 12 Create the internal ATM port with the switch software addport command. The addport slot.1 command
activates the embedded UXM-E and powers on the embedded router. The router loads the Cisco IOS
configuration file from the Admin Flash on the URM.
Note By default, the URM’s internal ATM interface is a UNI port with a maximum bandwidth of
353,208 calls per second (cps) (equivalent to an OC-3 ATM port); the interface cannot be
configured as a NNI port.
Step 13 (Optional) Use the switch software cnfport command to configure the internal ATM port to support
ILMI.
Note The port does not support LMI management protocol and should be configured to support either
ILMI or none. If ILMI is not configured on the internal ATM port, the embedded UXM-E does
not discover the assigned IP addresses for the URM card.
Step 14 Activate the internal ATM port with the switch software upport command.
Step 15 Configure ATM connections onto the embedded UXM-E with the switch software addcon command.
For more information on configuring ATM connections, see Chapter 8, “Cisco IGX 8400 Series ATM
Service”
Timesaver If you want the Cisco IOS configuration to load from NVRAM in the future, use the switch software
cnfrtr slot r command at the switch software CLI.
Step 16 Use switch software commands to configure ATM connections onto the embedded UXM-E.
Step 17 Use Cisco IOS commands to configure voice and data connections onto the embedded router.
Step 18 Write the modified Cisco IOS configuration to the embedded router NVRAM with the Cisco IOS copy
run start command.
Step 19 Configure the embedded router to load the Cisco IOS configuration from the embedded router NVRAM
with the switch software cnfrtr slot r 1 command.
Step 20 Clear the NPM DRAM for future downloads of firmware and switch software images, or for updated
Cisco IOS configuration files, with the switch software clrrtrcnf command.
For information on switch software commands, refer to the “WAN Switch Software for the URM”
section on page 2-102, or to the Cisco WAN Switching Command Reference.