Specifications

2-95
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
Universal Router Module
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
Primary Rate ISDN software, Version 1.1.
--More--
IGX slot number 15
URM image loaded from flash (controlled by "cnfrtrparm" on IGX)
URM booting with BLANK configuration (controlled by "cnfrtr" on IGX)
Front card type:URM Main Board
Back card type:URI-2FE2V
2 FastEthernet/IEEE 802.3 interface(s)
1 ATM network interface(s)
2 Channelized T1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
123K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
8192K bytes of processor board Boot flash (Read/Write)
Configuration register is 0x101
Router#
Step 10 (Optional) To enter the Cisco IOS setup utility for basic configuration information, use the Cisco IOS
setup command.
Timesaver Perform remaining configuration tasks with RRC. See the “Initial URM Configuration Using RRC”
section on page 2-96.
Step 11 Configure an IP address onto the internal ATM interface by running the Cisco IOS command ip address
command in the embedded router’s interface configuration mode.
Timesaver Cisco IOS software does not automatically save configuration changes to the embedded router NVRAM.
To avoid losing configuration changes, use the Cisco IOS copy run start command to save copies of
your Cisco IOS running configuration to the embedded router NVRAM while you are working.
Step 12 Connect the management network with the embedded router through an IP-based protocol (such as
Telnet, FTP, or TFTP). When connected, the embedded router reports assigned IP addresses to the
embedded UXM-E through an ILMI topology discovery.
Tip Use the IP address configured on the internal ATM interface as the endpoint for a management VC
between the URM and the management network.
Note For ILMI to discover and display the IP address, the internal ATM interface must have a
configured IP address and ILMI must be configured on the internal ATM port. The ILMI
protocol does not exchange any other IP addresses with the IGX.
Step 13 To configure ports on the URM, use Cisco IOS CLI commands. For more information on how to access
Cisco IOS software documentation, see the “Accessing User Documentation” section on page xii.
Step 14 Configure voice connections on the URM using Cisco IOS CLI and switch software CLI commands. For
more information, refer to switch software or Cisco IOS documentation listed in the “Accessing User
Documentation” section on page xii.